Camlok Pulling Clamps

Camlok "TSH" Swivel Hook Screw Pulling Clamp Range 750kg to 5000kg

With Alloy Safety Shackle Pulling up to 180 degrees

Model: CTSH-4308

From £449.32 The Camlok series of screwcam clamps can be used on all structural steel plates and sections up to a surface hardness of 300 Brinell. They offer an easy way of attaching pulling equipment to steel structures and can be used for holding and for the correction of alignment problems. This range of clamps is designed for pulling in three planes. The design allows for simultaneous loading in two directions but not for the transportation of plate.

This series of clamps can be used in any combination or number of combinations required they are available in various sizes, lifting capacities and cap sizes.

Camlok "TSZ" Two-Way Pulling Screw Clamp Range 500kg to 7500kg

With two lifting points

Model: CTTP-4309

From £456.16

The Camlok series of screwcam clamps can be used on all structural steel plates and sections up to a surface hardness of 300 Brinell. They offer an easy way of attaching pulling equipment to steel structures and can be used for holding and for the correction of alignment problems. This range of clamps is designed for pulling in three planes. The design allows for simultaneous loading in two directions but not for the transportation of plate.

This series of clamps can be used in any combination or number of combinations required they are available in various sizes, lifting capacities and cap sizes.